I have been searching the forums and the site, but I have not found the answer. I see that the minimum drill diameter for PCB-Pool standard service is 0.3mm, and the maximum is 6mm. I would like to know the sizes of the other standard drills on this rack.
Hi Craig,
You can request any drill size from 0.3mm to 6.0mm in increments of 0.05mm.
If you require a drill size greater than 6.0mm then a rout charge will apply.
Please also have a look at the attached spec sheet for our drilling tolerances.
Cookies facilitate the provision of our services. By clicking the "Accept all cookies" button, you allow all cookies including the marketing cookies from third parties for statistics and newsletter analysis. If you reject all cookies, only BETA cookies technically necessary to provide this service will be used. Learn more